سیمولینک شبکه قدرت

Collapse
X
 
  • زمان
  • نمایش
Clear All
new posts
  • amin_pwa
    • 2008/10/09
    • 8

    #1

    سیمولینک شبکه قدرت

    با سلام خدمت همه
    در قسمت متلب سیمولینک ، مدار ساده زیر رو می کشم ولی با ارور زیر مواجه میشم ، طبق ارور میگه چنین عناصری وجود نداره !
    لطفا برای حل این مشکل راهنمایی کنید .
    با تشکر




    Error in 'untitled/AC Voltage Source': Initialization commands cannot be evaluated.

    The diagram must contain a powergui block. The block must be named powergui and should be located at the highest level of your diagram where SimPowerSystems blocks are found.
    Component: ******** | Category: Block errorOpen

    Error in 'untitled/AC Voltage Source1': Initialization commands cannot be evaluated.

    The diagram must contain a powergui block. The block must be named powergui and should be located at the highest level of your diagram where SimPowerSystems blocks are found.
    Component: ******** | Category: Block error

    Error in 'untitled/Voltage Measurement': Initialization commands cannot be evaluated.

    The diagram must contain a powergui block. The block must be named powergui and should be located at the highest level of your diagram where SimPowerSystems blocks are found.
    Component: ******** | Category: Block error

    فایل سیمولینک
  • amin_pwa
    • 2008/10/09
    • 8

    #2
    پاسخ : سیمولینک شبکه قدرت

    مشکل حل شد .

    Note When you start the simulation, you will get an error if no Powergui block is found in your model.

    دیدگاه

    • ms.malmir
      • 2015/04/20
      • 1

      #3
      پاسخ : سیمولینک شبکه قدرت

      با سلام
      امین جان میشه بگی مشکلت چطور حل شد؟
      اخه منم همین مشکل رو دارم
      ممنون

      دیدگاه

      • miladeng98
        • 2012/08/09
        • 88

        #4
        پاسخ : سیمولینک شبکه قدرت

        بلوک مربوط به شبیه سازی رو باید بذاری همون بلوکی که به هیچ چیز وصل نیست ولی تا نباشه شبیه سازی انجام نمیشه powergui بود فک کنم

        دیدگاه

        لطفا صبر کنید...